+#define TRX_MAGIC 0x30524448 /* "HDR0" */
+#define TRX_MAX_OFFSET 3 /* Max number of file offsets */
+#define TRX_UNCOMP_IMAGE 0x20 /* Trx holds uncompressed img */
+#define TRX_RDL_CHUNK 1500 /* size of each dl transfer */
+#define TRX_OFFSETS_DLFWLEN_IDX 0
+
+/* Control messages: bRequest values */
+#define DL_GETSTATE 0 /* returns the rdl_state_t struct */
+#define DL_CHECK_CRC 1 /* currently unused */
+#define DL_GO 2 /* execute downloaded image */
+#define DL_START 3 /* initialize dl state */
+#define DL_REBOOT 4 /* reboot the device in 2 seconds */
+#define DL_GETVER 5 /* returns the bootrom_id_t struct */
+#define DL_GO_PROTECTED 6 /* execute the downloaded code and set reset
+ * event to occur in 2 seconds. It is the
+ * responsibility of the downloaded code to
+ * clear this event
+ */
+#define DL_EXEC 7 /* jump to a supplied address */
+#define DL_RESETCFG 8 /* To support single enum on dongle
+ * - Not used by bootloader
+ */
+#define DL_DEFER_RESP_OK 9 /* Potentially defer the response to setup
+ * if resp unavailable
+ */
+
+/* states */
+#define DL_WAITING 0 /* waiting to rx first pkt */
+#define DL_READY 1 /* hdr was good, waiting for more of the
+ * compressed image
+ */
+#define DL_BAD_HDR 2 /* hdr was corrupted */
+#define DL_BAD_CRC 3 /* compressed image was corrupted */
+#define DL_RUNNABLE 4 /* download was successful,waiting for go cmd */
+#define DL_START_FAIL 5 /* failed to initialize correctly */
+#define DL_NVRAM_TOOBIG 6 /* host specified nvram data exceeds DL_NVRAM
+ * value
+ */
+#define DL_IMAGE_TOOBIG 7 /* firmware image too big */
+
+
+struct trx_header_le {
+ __le32 magic; /* "HDR0" */
+ __le32 len; /* Length of file including header */
+ __le32 crc32; /* CRC from flag_version to end of file */
+ __le32 flag_version; /* 0:15 flags, 16:31 version */
+ __le32 offsets[TRX_MAX_OFFSET]; /* Offsets of partitions from start of
+ * header
+ */
+};
+
+struct rdl_state_le {
+ __le32 state;
+ __le32 bytes;
+};
+
+struct bootrom_id_le {
+ __le32 chip; /* Chip id */
+ __le32 chiprev; /* Chip rev */
+ __le32 ramsize; /* Size of RAM */
+ __le32 remapbase; /* Current remap base address */
+ __le32 boardtype; /* Type of board */
+ __le32 boardrev; /* Board revision */
+};
+