select HAVE_GENERIC_HARDIRQS
select HAVE_SPARSE_IRQ
select GENERIC_IRQ_SHOW
+ select CPU_PM if (SUSPEND || CPU_IDLE)
help
The ARM series is a line of low-power-consumption RISC chip designs
licensed by ARM Ltd and targeted at embedded applications and
processor into full low interrupt latency mode. ARM11MPCore
is not affected.
+config ARM_ERRATA_764369
+ bool "ARM errata: Data cache line maintenance operation by MVA may not succeed"
+ depends on CPU_V7 && SMP
+ help
+ This option enables the workaround for erratum 764369
+ affecting Cortex-A9 MPCore with two or more processors (all
+ current revisions). Under certain timing circumstances, a data
+ cache line maintenance operation by MVA targeting an Inner
+ Shareable memory region may fail to proceed up to either the
+ Point of Coherency or to the Point of Unification of the
+ system. This workaround adds a DSB instruction before the
+ relevant cache maintenance functions and sets a specific bit
+ in the diagnostic control register of the SCU.
+
endmenu
source "arch/arm/common/Kconfig"
endchoice
+config ARM_APPENDED_DTB
+ bool "Use appended device tree blob to zImage (EXPERIMENTAL)"
+ depends on OF && !ZBOOT_ROM && EXPERIMENTAL
+ help
+ With this option, the boot code will look for a device tree binary
+ (DTB) appended to zImage
+ (e.g. cat zImage <filename>.dtb > zImage_w_dtb).
+
+ This is meant as a backward compatibility convenience for those
+ systems with a bootloader that can't be upgraded to accommodate
+ the documented boot protocol using a device tree.
+
+ Beware that there is very little in terms of protection against
+ this option being confused by leftover garbage in memory that might
+ look like a DTB header after a reboot if no actual DTB is appended
+ to zImage. Do not leave this option active in a production kernel
+ if you don't intend to always append a DTB. Proper passing of the
+ location into r2 of a bootloader provided DTB is always preferable
+ to this option.
+
+config ARM_ATAG_DTB_COMPAT
+ bool "Supplement the appended DTB with traditional ATAG information"
+ depends on ARM_APPENDED_DTB
+ help
+ Some old bootloaders can't be updated to a DTB capable one, yet
+ they provide ATAGs with memory configuration, the ramdisk address,
+ the kernel cmdline string, etc. Such information is dynamically
+ provided by the bootloader and can't always be stored in a static
+ DTB. To allow a device tree enabled kernel to be used with such
+ bootloaders, this option allows zImage to extract the information
+ from the ATAG list and store it at run time into the appended DTB.
+
config CMDLINE
string "Default kernel command string"
default ""