ARM: dts: sun5i: Enable mmc controller on various A10s and A13 boards

[cascardo/linux.git] / arch / arm / boot / dts / sun5i-a13-olinuxino.dts

diff --git a/arch/arm/boot/dts/sun5i-a13-olinuxino.dts b/arch/arm/boot/dts/sun5i-a13-olinuxino.dts
index a4ba5ff..51a9438 100644 (file)
--- a/arch/arm/boot/dts/sun5i-a13-olinuxino.dts
+++ b/arch/arm/boot/dts/sun5i-a13-olinuxino.dts
@@ -13,19 +13,56 @@
 
 /dts-v1/;
 /include/ "sun5i-a13.dtsi"
+/include/ "sunxi-common-regulators.dtsi"
 
 / {
        model = "Olimex A13-Olinuxino";
        compatible = "olimex,a13-olinuxino", "allwinner,sun5i-a13";
 
        soc@01c00000 {
+               mmc0: mmc@01c0f000 {
+                       pinctrl-names = "default";
+                       pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_olinuxino>;
+                       bus-width = <4>;
+                       cd-gpios = <&pio 6 0 0>; /* PG0 */
+                       cd-inverted;
+                       status = "okay";
+               };
+
+               usbphy: phy@01c13400 {
+                       usb1_vbus-supply = <&reg_usb1_vbus>;
+                       status = "okay";
+               };
+
+               ehci0: usb@01c14000 {
+                       status = "okay";
+               };
+
+               ohci0: usb@01c14400 {
+                       status = "okay";
+               };
+
                pinctrl@01c20800 {
+                       mmc0_cd_pin_olinuxino: mmc0_cd_pin@0 {
+                               allwinner,pins = "PG0";
+                               allwinner,function = "gpio_in";
+                               allwinner,drive = <0>;
+                               allwinner,pull = <1>;
+                       };
+
                        led_pins_olinuxino: led_pins@0 {
                                allwinner,pins = "PG9";
                                allwinner,function = "gpio_out";
                                allwinner,drive = <1>;
                                allwinner,pull = <0>;
                        };
+
+                       usb1_vbus_pin_olinuxino: usb1_vbus_pin@0 {
+                               allwinner,pins = "PG11";
+                               allwinner,function = "gpio_out";
+                               allwinner,drive = <0>;
+                               allwinner,pull = <0>;
+                       };
                };
 
                uart1: serial@01c28400 {
@@ -63,4 +100,10 @@
                        default-state = "on";
                };
        };
+
+       reg_usb1_vbus: usb1-vbus {
+               pinctrl-0 = <&usb1_vbus_pin_olinuxino>;
+               gpio = <&pio 6 11 0>;
+               status = "okay";
+       };
 };