/**
* omap2_prm_is_hardreset_asserted - read the HW reset line state of
* submodules contained in the hwmod module
- * @prm_mod: PRM submodule base (e.g. CORE_MOD)
* @shift: register bit shift corresponding to the reset line to check
+ * @part: PRM partition, ignored for OMAP2
+ * @prm_mod: PRM submodule base (e.g. CORE_MOD)
+ * @offset: register offset, ignored for OMAP2
*
* Returns 1 if the (sub)module hardreset line is currently asserted,
* 0 if the (sub)module hardreset line is not currently asserted, or
* -EINVAL if called while running on a non-OMAP2/3 chip.
*/
-int omap2_prm_is_hardreset_asserted(s16 prm_mod, u8 shift)
+int omap2_prm_is_hardreset_asserted(u8 shift, u8 part, s16 prm_mod, u16 offset)
{
return omap2_prm_read_mod_bits_shift(prm_mod, OMAP2_RM_RSTCTRL,
(1 << shift));
/**
* omap2_prm_assert_hardreset - assert the HW reset line of a submodule
- * @prm_mod: PRM submodule base (e.g. CORE_MOD)
* @shift: register bit shift corresponding to the reset line to assert
+ * @part: PRM partition, ignored for OMAP2
+ * @prm_mod: PRM submodule base (e.g. CORE_MOD)
+ * @offset: register offset, ignored for OMAP2
*
* Some IPs like dsp or iva contain processors that require an HW
* reset line to be asserted / deasserted in order to fully enable the
* place the submodule into reset. Returns 0 upon success or -EINVAL
* upon an argument error.
*/
-int omap2_prm_assert_hardreset(s16 prm_mod, u8 shift)
+int omap2_prm_assert_hardreset(u8 shift, u8 part, s16 prm_mod, u16 offset)
{
u32 mask;
* @prm_mod: PRM submodule base (e.g. CORE_MOD)
* @rst_shift: register bit shift corresponding to the reset line to deassert
* @st_shift: register bit shift for the status of the deasserted submodule
+ * @part: PRM partition, not used for OMAP2
+ * @prm_mod: PRM submodule base (e.g. CORE_MOD)
+ * @rst_offset: reset register offset, not used for OMAP2
+ * @st_offset: reset status register offset, not used for OMAP2
*
* Some IPs like dsp or iva contain processors that require an HW
* reset line to be asserted / deasserted in order to fully enable the
* -EINVAL upon an argument error, -EEXIST if the submodule was already out
* of reset, or -EBUSY if the submodule did not exit reset promptly.
*/
-int omap2_prm_deassert_hardreset(s16 prm_mod, u8 rst_shift, u8 st_shift)
+int omap2_prm_deassert_hardreset(u8 rst_shift, u8 st_shift, u8 part,
+ s16 prm_mod, u16 rst_offset, u16 st_offset)
{
u32 rst, st;
int c;