{
lguest_data.pgdir = cr3;
lazy_hcall1(LHCALL_NEW_PGTABLE, cr3);
- cr3_changed = true;
+
+ /* These two page tables are simple, linear, and used during boot */
+ if (cr3 != __pa(swapper_pg_dir) && cr3 != __pa(initial_page_table))
+ cr3_changed = true;
}
static unsigned long lguest_read_cr3(void)
* to forget all of them. Fortunately, this is very rare.
*
* ... except in early boot when the kernel sets up the initial pagetables,
- * which makes booting astonishingly slow: 1.83 seconds! So we don't even tell
- * the Host anything changed until we've done the first page table switch,
- * which brings boot back to 0.25 seconds.
+ * which makes booting astonishingly slow: 48 seconds! So we don't even tell
+ * the Host anything changed until we've done the first real page table switch,
+ * which brings boot back to 4.3 seconds.
*/
static void lguest_set_pte(pte_t *ptep, pte_t pteval)
{
* simple as setting a bit. We don't actually "ack" interrupts as such, we
* just mask and unmask them. I wonder if we should be cleverer?
*/
-static void disable_lguest_irq(unsigned int irq)
+static void disable_lguest_irq(struct irq_data *data)
{
- set_bit(irq, lguest_data.blocked_interrupts);
+ set_bit(data->irq, lguest_data.blocked_interrupts);
}
-static void enable_lguest_irq(unsigned int irq)
+static void enable_lguest_irq(struct irq_data *data)
{
- clear_bit(irq, lguest_data.blocked_interrupts);
+ clear_bit(data->irq, lguest_data.blocked_interrupts);
}
/* This structure describes the lguest IRQ controller. */
static struct irq_chip lguest_irq_controller = {
.name = "lguest",
- .mask = disable_lguest_irq,
- .mask_ack = disable_lguest_irq,
- .unmask = enable_lguest_irq,
+ .irq_mask = disable_lguest_irq,
+ .irq_mask_ack = disable_lguest_irq,
+ .irq_unmask = enable_lguest_irq,
};
/*
* rather than set them in lguest_init_IRQ we are called here every time an
* lguest device needs an interrupt.
*
- * FIXME: irq_to_desc_alloc_node() can fail due to lack of memory, we should
+ * FIXME: irq_alloc_desc_at() can fail due to lack of memory, we should
* pass that up!
*/
void lguest_setup_irq(unsigned int irq)
{
- irq_to_desc_alloc_node(irq, 0);
+ irq_alloc_desc_at(irq, 0);
set_irq_chip_and_handler_name(irq, &lguest_irq_controller,
handle_level_irq, "level");
}
clockevents_register_device(&lguest_clockevent);
/* Finally, we unblock the timer interrupt. */
- enable_lguest_irq(0);
+ clear_bit(0, lguest_data.blocked_interrupts);
}
/*
*/
switch_to_new_gdt(0);
- /* We actually boot with all memory mapped, but let's say 128MB. */
- max_pfn_mapped = (128*1024*1024) >> PAGE_SHIFT;
-
/*
* The Host<->Guest Switcher lives at the top of our address space, and
* the Host told us how big it is when we made LGUEST_INIT hypercall: