staging: ks7010: bail out when registering netdevice fails

[cascardo/linux.git] / drivers / cpufreq / Kconfig

diff --git a/drivers/cpufreq/Kconfig b/drivers/cpufreq/Kconfig
index a7f4585..b7445b6 100644 (file)
--- a/drivers/cpufreq/Kconfig
+++ b/drivers/cpufreq/Kconfig
@@ -18,7 +18,11 @@ config CPU_FREQ
 
 if CPU_FREQ
 
+config CPU_FREQ_GOV_ATTR_SET
+       bool
+
 config CPU_FREQ_GOV_COMMON
+       select CPU_FREQ_GOV_ATTR_SET
        select IRQ_WORK
        bool
 
@@ -103,6 +107,17 @@ config CPU_FREQ_DEFAULT_GOV_CONSERVATIVE
          Be aware that not all cpufreq drivers support the conservative
          governor. If unsure have a look at the help section of the
          driver. Fallback governor will be the performance governor.
+
+config CPU_FREQ_DEFAULT_GOV_SCHEDUTIL
+       bool "schedutil"
+       depends on SMP
+       select CPU_FREQ_GOV_SCHEDUTIL
+       select CPU_FREQ_GOV_PERFORMANCE
+       help
+         Use the 'schedutil' CPUFreq governor by default. If unsure,
+         have a look at the help section of that governor. The fallback
+         governor will be 'performance'.
+
 endchoice
 
 config CPU_FREQ_GOV_PERFORMANCE
@@ -184,6 +199,26 @@ config CPU_FREQ_GOV_CONSERVATIVE
 
          If in doubt, say N.
 
+config CPU_FREQ_GOV_SCHEDUTIL
+       tristate "'schedutil' cpufreq policy governor"
+       depends on CPU_FREQ && SMP
+       select CPU_FREQ_GOV_ATTR_SET
+       select IRQ_WORK
+       help
+         This governor makes decisions based on the utilization data provided
+         by the scheduler.  It sets the CPU frequency to be proportional to
+         the utilization/capacity ratio coming from the scheduler.  If the
+         utilization is frequency-invariant, the new frequency is also
+         proportional to the maximum available frequency.  If that is not the
+         case, it is proportional to the current frequency of the CPU.  The
+         frequency tipping point is at utilization/capacity equal to 80% in
+         both cases.
+
+         To compile this driver as a module, choose M here: the module will
+         be called cpufreq_schedutil.
+
+         If in doubt, say N.
+
 comment "CPU frequency scaling drivers"
 
 config CPUFREQ_DT
@@ -191,6 +226,7 @@ config CPUFREQ_DT
        depends on HAVE_CLK && OF
        # if CPU_THERMAL is on and THERMAL=m, CPUFREQ_DT cannot be =y:
        depends on !CPU_THERMAL || THERMAL
+       select CPUFREQ_DT_PLATDEV
        select PM_OPP
        help
          This adds a generic DT based cpufreq driver for frequency management.
@@ -199,6 +235,15 @@ config CPUFREQ_DT
 
          If in doubt, say N.
 
+config CPUFREQ_DT_PLATDEV
+       bool
+       help
+         This adds a generic DT based cpufreq platdev driver for frequency
+         management.  This creates a 'cpufreq-dt' platform device, on the
+         supported platforms.
+
+         If in doubt, say N.
+
 if X86
 source "drivers/cpufreq/Kconfig.x86"
 endif