struct ieee80211_channel *geo_ch;
struct ieee80211_rate *rates;
int i = 0;
+ s8 max_tx_power = 0;
if (priv->bands[IEEE80211_BAND_2GHZ].n_bitrates ||
priv->bands[IEEE80211_BAND_5GHZ].n_bitrates) {
if (!iwl_legacy_is_channel_valid(ch))
continue;
- if (iwl_legacy_is_channel_a_band(ch))
- sband = &priv->bands[IEEE80211_BAND_5GHZ];
- else
- sband = &priv->bands[IEEE80211_BAND_2GHZ];
+ sband = &priv->bands[ch->band];
geo_ch = &sband->channels[sband->n_channels++];
geo_ch->flags |= ch->ht40_extension_channel;
- if (ch->max_power_avg > priv->tx_power_device_lmt)
- priv->tx_power_device_lmt = ch->max_power_avg;
+ if (ch->max_power_avg > max_tx_power)
+ max_tx_power = ch->max_power_avg;
} else {
geo_ch->flags |= IEEE80211_CHAN_DISABLED;
}
geo_ch->flags);
}
+ priv->tx_power_device_lmt = max_tx_power;
+ priv->tx_power_user_lmt = max_tx_power;
+ priv->tx_power_next = max_tx_power;
+
if ((priv->bands[IEEE80211_BAND_5GHZ].n_channels == 0) &&
priv->cfg->sku & IWL_SKU_A) {
IWL_INFO(priv, "Incorrectly detected BG card as ABG. "
/*
* Enable HAP INTA (interrupt from management bus) to
* wake device's PCI Express link L1a -> L0s
- * NOTE: This is no-op for 3945 (non-existant bit)
+ * NOTE: This is no-op for 3945 (non-existent bit)
*/
iwl_legacy_set_bit(priv, CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_BIT_HAP_WAKE_L1A);
if (!priv->cfg->ops->lib->send_tx_power)
return -EOPNOTSUPP;
- if (tx_power < IWL4965_TX_POWER_TARGET_POWER_MIN) {
+ /* 0 dBm mean 1 milliwatt */
+ if (tx_power < 0) {
IWL_WARN(priv,
- "Requested user TXPOWER %d below lower limit %d.\n",
- tx_power,
- IWL4965_TX_POWER_TARGET_POWER_MIN);
+ "Requested user TXPOWER %d below 1 mW.\n",
+ tx_power);
return -EINVAL;
}
mutex_lock(&priv->mutex);
+ if (!ctx->vif || !iwl_legacy_is_ready_rf(priv)) {
+ /*
+ * Huh? But wait ... this can maybe happen when
+ * we're in the middle of a firmware restart!
+ */
+ err = -EBUSY;
+ goto out;
+ }
+
interface_modes = ctx->interface_modes | ctx->exclusive_interface_modes;
if (!(interface_modes & BIT(newtype))) {
/* success */
iwl_legacy_teardown_interface(priv, vif, true);
vif->type = newtype;
+ vif->p2p = newp2p;
err = iwl_legacy_setup_interface(priv, ctx);
WARN_ON(err);
/*
IWL_DEBUG_MAC80211(priv, "enter to channel %d changed 0x%X\n",
channel->hw_value, changed);
- if (unlikely(!priv->cfg->mod_params->disable_hw_scan &&
- test_bit(STATUS_SCANNING, &priv->status))) {
+ if (unlikely(test_bit(STATUS_SCANNING, &priv->status))) {
scan_active = 1;
- IWL_DEBUG_MAC80211(priv, "leave - scanning\n");
+ IWL_DEBUG_MAC80211(priv, "scan active\n");
}
if (changed & (IEEE80211_CONF_CHANGE_SMPS |
IWL_DEBUG_MAC80211(priv, "changes = 0x%X\n", changes);
- if (!iwl_legacy_is_alive(priv))
- return;
-
mutex_lock(&priv->mutex);
+ if (!iwl_legacy_is_alive(priv)) {
+ mutex_unlock(&priv->mutex);
+ return;
+ }
+
if (changes & BSS_CHANGED_QOS) {
unsigned long flags;
none:
/* re-enable interrupts here since we don't have anything to service. */
- /* only Re-enable if diabled by irq */
+ /* only Re-enable if disabled by irq */
if (test_bit(STATUS_INT_ENABLED, &priv->status))
iwl_legacy_enable_interrupts(priv);
spin_unlock_irqrestore(&priv->lock, flags);