Merge branch 'for-linus' of git://git390.marist.edu/pub/scm/linux-2.6

[cascardo/linux.git] / drivers / scsi / aic7xxx / Kconfig.aic7xxx

diff --git a/drivers/scsi/aic7xxx/Kconfig.aic7xxx b/drivers/scsi/aic7xxx/Kconfig.aic7xxx
index 6c2c395..88da670 100644 (file)
--- a/drivers/scsi/aic7xxx/Kconfig.aic7xxx
+++ b/drivers/scsi/aic7xxx/Kconfig.aic7xxx
@@ -27,12 +27,12 @@ config AIC7XXX_CMDS_PER_DEVICE
        to be used for any device.  The aic7xxx driver will automatically
        vary this number based on device behavior.  For devices with a
        fixed maximum, the driver will eventually lock to this maximum
-       and display a console message inidicating this value.
+       and display a console message indicating this value.
 
        Due to resource allocation issues in the Linux SCSI mid-layer, using
        a high number of commands per device may result in memory allocation
        failures when many devices are attached to the system.  For this reason,
-       the default is set to 32.  Higher values may result in higer performance
+       the default is set to 32.  Higher values may result in higher performance
        on some devices.  The upper bound is 253.  0 disables tagged queueing.
 
        Per device tag depth can be controlled via the kernel command line
@@ -50,16 +50,6 @@ config AIC7XXX_RESET_DELAY_MS
 
        Default: 5000 (5 seconds)
 
-config AIC7XXX_PROBE_EISA_VL
-       bool "Probe for EISA and VL AIC7XXX Adapters"
-       depends on SCSI_AIC7XXX && EISA
-       help
-       Probe for EISA and VLB Aic7xxx controllers.  In many newer systems,
-       the invasive probes necessary to detect these controllers can cause
-       other devices to fail.  For this reason, the non-PCI probe code is
-       disabled by default.  The current value of this option can be "toggled"
-       via the no_probe kernel command line option.
-
 config AIC7XXX_BUILD_FIRMWARE
        bool "Build Adapter Firmware with Kernel Build"
        depends on SCSI_AIC7XXX && !PREVENT_FIRMWARE_BUILD
@@ -86,7 +76,7 @@ config AIC7XXX_DEBUG_MASK
         default "0"
         help
        Bit mask of debug options that is only valid if the
-       CONFIG_AIC7XXX_DEBUG_ENBLE option is enabled.  The bits in this mask
+       CONFIG_AIC7XXX_DEBUG_ENABLE option is enabled.  The bits in this mask
        are defined in the drivers/scsi/aic7xxx/aic7xxx.h - search for the
        variable ahc_debug in that file to find them.