- Integrate ql12160_set_target_parameters() with 1280 version
- Make qla1280_setup() non static
- Do not call qla1280_check_for_dead_scsi_bus() on every I/O request
- sent to the card - this command pauses the firmare!!!
+ sent to the card - this command pauses the firmware!!!
Rev 3.23.15 Beta March 19, 2002, Jes Sorensen
- Clean up qla1280.h - remove obsolete QL_DEBUG_LEVEL_x definitions
- Remove a pile of pointless and confusing (srb_t **) and
/* The firmware interface is, um, interesting, in that the
* actual firmware image on the chip is little endian, thus,
* the process of taking that image to the CPU would end up
- * little endian. However, the firmare interface requires it
+ * little endian. However, the firmware interface requires it
* to be read a word (two bytes) at a time.
*
* The net result of this would be that the word (and
error = -ENODEV;
#if MEMORY_MAPPED_IO
- ha->mmpbase = ioremap(pci_resource_start(ha->pdev, 1),
- pci_resource_len(ha->pdev, 1));
+ ha->mmpbase = pci_ioremap_bar(ha->pdev, 1);
if (!ha->mmpbase) {
printk(KERN_INFO "qla1280: Unable to map I/O memory\n");
goto error_free_response_ring;