* constant definitions
******************************************************************************/
-/* Allow support for calling system fcns to access F/W iamge file */
+/* Allow support for calling system fcns to access F/W image file */
#define __KERNEL_SYSCALLS__
/*******************************************************************************
#include <wl_pci.h>
#endif /* BUS_PCI */
/*******************************************************************************
- * macro defintions
+ * macro definitions
******************************************************************************/
#define VALID_PARAM(C) \
{ \
CNV_INT_TO_LITTLE( lp->hcfCtx.IFB_FWIdentity.version_major ),
CNV_INT_TO_LITTLE( lp->hcfCtx.IFB_FWIdentity.version_minor ));
- /* now we wil get the MAC address of the card */
+ /* now we will get the MAC address of the card */
lp->ltvRecord.len = 4;
if ( CNV_INT_TO_LITTLE( lp->hcfCtx.IFB_FWIdentity.comp_id ) == COMP_ID_FW_AP ) {
lp->ltvRecord.typ = CFG_NIC_MAC_ADDR;
lp->ltvRecord.len = 2;
lp->ltvRecord.typ = CFG_CNTL_OPT;
- /* The Card Services build must ALWAYS configure for 16-bit I/O. PCI or
+ /* The Card Services build must ALWAYS be configured for 16-bit I/O. PCI or
CardBus can be set to either 16/32 bit I/O, or Bus Master DMA, but only
for Hermes-2.5 */
#ifdef BUS_PCMCIA
lp->ltvRecord.u.u16[0] = CNV_INT_TO_LITTLE( lp->TxRateControl[0] );
#endif // WARP
-//;?skip temporarily to see whether the RID or something else is the probelm hcf_status = hcf_put_info( &lp->hcfCtx, (LTVP)&( lp->ltvRecord ));
+//;?skip temporarily to see whether the RID or something else is the problem hcf_status = hcf_put_info( &lp->hcfCtx, (LTVP)&( lp->ltvRecord ));
DBG_TRACE( DbgInfo, "CFG_TX_RATE_CNTL 2.4GHz : 0x%04x\n",
lp->TxRateControl[0] );
*
* DESCRIPTION:
*
- * This function perfroms a check on the device and calls wl_remove() if
+ * This function performs a check on the device and calls wl_remove() if
* necessary. This function can be used for all bus types, but exists mostly
* for the benefit of the Card Services driver, as there are times when
* wl_remove() does not get called.
lp->portState = WVLAN_PORT_STATE_ENABLED; //;?bad mnemonic, NIC iso PORT
#ifdef ENABLE_DMA
if ( lp->use_dma ) {
- wl_pci_dma_hcf_supply( lp ); //;?always succes?
+ wl_pci_dma_hcf_supply( lp ); //;?always successful?
}
#endif
}
* DESCRIPTION:
*
* This function will perform the tedious task of endian translating all
- * fields withtin a mailbox message which need translating.
+ * fields within a mailbox message which need translating.
*
* PARAMETERS:
*
*
* DESCRIPTION:
*
- * This function will process the mailbox data.
+ * This function processes the mailbox data.
*
* PARAMETERS:
*