Pull bsp-removal into release branch

[cascardo/linux.git] / drivers / w1 / Kconfig

diff --git a/drivers/w1/Kconfig b/drivers/w1/Kconfig
index 4f12079..4baf61a 100644 (file)
--- a/drivers/w1/Kconfig
+++ b/drivers/w1/Kconfig
@@ -3,7 +3,7 @@ menu "Dallas's 1-wire bus"
 config W1
        tristate "Dallas's 1-wire support"
        ---help---
-         Dallas's 1-wire bus is usefull to connect slow 1-pin devices
+         Dallas's 1-wire bus is useful to connect slow 1-pin devices
          such as iButtons and thermal sensors.
 
          If you want W1 support, you should say Y here.
@@ -30,7 +30,7 @@ config W1_DS9490
          This support is also available as a module.  If so, the module
          will be called ds9490r.ko.
 
-config W1_DS9490R_BRIDGE
+config W1_DS9490_BRIDGE
        tristate "DS9490R USB <-> W1 transport layer for 1-wire"
        depends on W1_DS9490
        help
@@ -54,4 +54,20 @@ config W1_SMEM
          Say Y here if you want to connect 1-wire
          simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire.
 
+config W1_DS2433
+       tristate "4kb EEPROM family support (DS2433)"
+       depends on W1
+       help
+         Say Y here if you want to use a 1-wire
+         4kb EEPROM family device (DS2433).
+
+config W1_DS2433_CRC
+       bool "Protect DS2433 data with a CRC16"
+       depends on W1_DS2433
+       select CRC16
+       help
+         Say Y here to protect DS2433 data with a CRC16.
+         Each block has 30 bytes of data and a two byte CRC16.
+         Full block writes are only allowed if the CRC is valid.
+
 endmenu