bool radar_required;
};
-/**
- * enum plink_action - actions to perform in mesh peers
- *
- * @PLINK_ACTION_INVALID: action 0 is reserved
- * @PLINK_ACTION_OPEN: start mesh peer link establishment
- * @PLINK_ACTION_BLOCK: block traffic from this mesh peer
- */
-enum plink_actions {
- PLINK_ACTION_INVALID,
- PLINK_ACTION_OPEN,
- PLINK_ACTION_BLOCK,
-};
-
/**
* enum station_parameters_apply_mask - station parameter values to apply
* @STATION_PARAM_APPLY_UAPSD: apply new uAPSD parameters (uapsd_queues, max_sp)
* @STATION_PARAM_APPLY_CAPABILITY: apply new capability
+ * @STATION_PARAM_APPLY_PLINK_STATE: apply new plink state
*
* Not all station parameters have in-band "no change" signalling,
* for those that don't these flags will are used.
enum station_parameters_apply_mask {
STATION_PARAM_APPLY_UAPSD = BIT(0),
STATION_PARAM_APPLY_CAPABILITY = BIT(1),
+ STATION_PARAM_APPLY_PLINK_STATE = BIT(2),
};
/**
* @ext_capab_len: number of extended capabilities
*/
struct station_parameters {
- u8 *supported_rates;
+ const u8 *supported_rates;
struct net_device *vlan;
u32 sta_flags_mask, sta_flags_set;
u32 sta_modify_mask;
u8 supported_rates_len;
u8 plink_action;
u8 plink_state;
- struct ieee80211_ht_cap *ht_capa;
- struct ieee80211_vht_cap *vht_capa;
+ const struct ieee80211_ht_cap *ht_capa;
+ const struct ieee80211_vht_cap *vht_capa;
u8 uapsd_queues;
u8 max_sp;
enum nl80211_mesh_power_mode local_pm;
u16 capability;
- u8 *ext_capab;
+ const u8 *ext_capab;
u8 ext_capab_len;
};
+/**
+ * enum cfg80211_station_type - the type of station being modified
+ * @CFG80211_STA_AP_CLIENT: client of an AP interface
+ * @CFG80211_STA_AP_MLME_CLIENT: client of an AP interface that has
+ * the AP MLME in the device
+ * @CFG80211_STA_AP_STA: AP station on managed interface
+ * @CFG80211_STA_IBSS: IBSS station
+ * @CFG80211_STA_TDLS_PEER_SETUP: TDLS peer on managed interface (dummy entry
+ * while TDLS setup is in progress, it moves out of this state when
+ * being marked authorized; use this only if TDLS with external setup is
+ * supported/used)
+ * @CFG80211_STA_TDLS_PEER_ACTIVE: TDLS peer on managed interface (active
+ * entry that is operating, has been marked authorized by userspace)
+ * @CFG80211_STA_MESH_PEER_KERNEL: peer on mesh interface (kernel managed)
+ * @CFG80211_STA_MESH_PEER_USER: peer on mesh interface (user managed)
+ */
+enum cfg80211_station_type {
+ CFG80211_STA_AP_CLIENT,
+ CFG80211_STA_AP_MLME_CLIENT,
+ CFG80211_STA_AP_STA,
+ CFG80211_STA_IBSS,
+ CFG80211_STA_TDLS_PEER_SETUP,
+ CFG80211_STA_TDLS_PEER_ACTIVE,
+ CFG80211_STA_MESH_PEER_KERNEL,
+ CFG80211_STA_MESH_PEER_USER,
+};
+
+/**
+ * cfg80211_check_station_change - validate parameter changes
+ * @wiphy: the wiphy this operates on
+ * @params: the new parameters for a station
+ * @statype: the type of station being modified
+ *
+ * Utility function for the @change_station driver method. Call this function
+ * with the appropriate station type looking up the station (and checking that
+ * it exists). It will verify whether the station change is acceptable, and if
+ * not will return an error code. Note that it may modify the parameters for
+ * backward compatibility reasons, so don't use them before calling this.
+ */
+int cfg80211_check_station_change(struct wiphy *wiphy,
+ struct station_parameters *params,
+ enum cfg80211_station_type statype);
+
/**
* enum station_info_flags - station information flags
*
* @ie_len: length of vendor information elements
* @is_authenticated: this mesh requires authentication
* @is_secure: this mesh uses security
+ * @user_mpm: userspace handles all MPM functions
* @dtim_period: DTIM period to use
* @beacon_interval: beacon interval to use
* @mcast_rate: multicat rate for Mesh Node [6Mbps is the default for 802.11a]
u8 ie_len;
bool is_authenticated;
bool is_secure;
+ bool user_mpm;
u8 dtim_period;
u16 beacon_interval;
int mcast_rate[IEEE80211_NUM_BANDS];
* enum cfg80211_assoc_req_flags - Over-ride default behaviour in association.
*
* @ASSOC_REQ_DISABLE_HT: Disable HT (802.11n)
+ * @ASSOC_REQ_DISABLE_VHT: Disable VHT
*/
enum cfg80211_assoc_req_flags {
ASSOC_REQ_DISABLE_HT = BIT(0),
+ ASSOC_REQ_DISABLE_VHT = BIT(1),
};
/**
* @ht_capa: HT Capabilities over-rides. Values set in ht_capa_mask
* will be used in ht_capa. Un-supported values will be ignored.
* @ht_capa_mask: The bits of ht_capa which are to be used.
+ * @vht_capa: VHT capability override
+ * @vht_capa_mask: VHT capability mask indicating which fields to use
*/
struct cfg80211_assoc_request {
struct cfg80211_bss *bss;
u32 flags;
struct ieee80211_ht_cap ht_capa;
struct ieee80211_ht_cap ht_capa_mask;
+ struct ieee80211_vht_cap vht_capa, vht_capa_mask;
};
/**
* @ht_capa: HT Capabilities over-rides. Values set in ht_capa_mask
* will be used in ht_capa. Un-supported values will be ignored.
* @ht_capa_mask: The bits of ht_capa which are to be used.
+ * @vht_capa: VHT Capability overrides
+ * @vht_capa_mask: The bits of vht_capa which are to be used.
*/
struct cfg80211_connect_params {
struct ieee80211_channel *channel;
int bg_scan_period;
struct ieee80211_ht_cap ht_capa;
struct ieee80211_ht_cap ht_capa_mask;
+ struct ieee80211_vht_cap vht_capa;
+ struct ieee80211_vht_cap vht_capa_mask;
};
/**
u8 replay_ctr[NL80211_REPLAY_CTR_LEN];
};
+/**
+ * struct cfg80211_update_ft_ies_params - FT IE Information
+ *
+ * This structure provides information needed to update the fast transition IE
+ *
+ * @md: The Mobility Domain ID, 2 Octet value
+ * @ie: Fast Transition IEs
+ * @ie_len: Length of ft_ie in octets
+ */
+struct cfg80211_update_ft_ies_params {
+ u16 md;
+ const u8 *ie;
+ size_t ie_len;
+};
+
/**
* struct cfg80211_ops - backend description for wireless configuration
*
* @change_station: Modify a given station. Note that flags changes are not much
* validated in cfg80211, in particular the auth/assoc/authorized flags
* might come to the driver in invalid combinations -- make sure to check
- * them, also against the existing state! Also, supported_rates changes are
- * not checked in station mode -- drivers need to reject (or ignore) them
- * for anything but TDLS peers.
+ * them, also against the existing state! Drivers must call
+ * cfg80211_check_station_change() to validate the information.
* @get_station: get station information for the station identified by @mac
* @dump_station: dump station callback -- resume dump at index @idx
*
* advertise the support for MAC based ACL have to implement this callback.
*
* @start_radar_detection: Start radar detection in the driver.
+ *
+ * @update_ft_ies: Provide updated Fast BSS Transition information to the
+ * driver. If the SME is in the driver/firmware, this information can be
+ * used in building Authentication and Reassociation Request frames.
+ *
+ * @crit_proto_start: Indicates a critical protocol needs more link reliability
+ * for a given duration (milliseconds). The protocol is provided so the
+ * driver can take the most appropriate actions.
+ * @crit_proto_stop: Indicates critical protocol no longer needs increased link
+ * reliability. This operation can not fail.
*/
struct cfg80211_ops {
int (*suspend)(struct wiphy *wiphy, struct cfg80211_wowlan *wow);
int (*start_radar_detection)(struct wiphy *wiphy,
struct net_device *dev,
struct cfg80211_chan_def *chandef);
+ int (*update_ft_ies)(struct wiphy *wiphy, struct net_device *dev,
+ struct cfg80211_update_ft_ies_params *ftie);
+ int (*crit_proto_start)(struct wiphy *wiphy,
+ struct wireless_dev *wdev,
+ enum nl80211_crit_proto_id protocol,
+ u16 duration);
+ void (*crit_proto_stop)(struct wiphy *wiphy,
+ struct wireless_dev *wdev);
};
/*
* @ap_sme_capa: AP SME capabilities, flags from &enum nl80211_ap_sme_features.
* @ht_capa_mod_mask: Specify what ht_cap values can be over-ridden.
* If null, then none can be over-ridden.
+ * @vht_capa_mod_mask: Specify what VHT capabilities can be over-ridden.
+ * If null, then none can be over-ridden.
*
* @max_acl_mac_addrs: Maximum number of MAC addresses that the device
* supports for ACL.
struct dentry *debugfsdir;
const struct ieee80211_ht_cap *ht_capa_mod_mask;
+ const struct ieee80211_vht_cap *vht_capa_mod_mask;
#ifdef CONFIG_NET_NS
/* the network namespace this phy lives in currently */
void cfg80211_ch_switch_notify(struct net_device *dev,
struct cfg80211_chan_def *chandef);
+/**
+ * ieee80211_operating_class_to_band - convert operating class to band
+ *
+ * @operating_class: the operating class to convert
+ * @band: band pointer to fill
+ *
+ * Returns %true if the conversion was successful, %false otherwise.
+ */
+bool ieee80211_operating_class_to_band(u8 operating_class,
+ enum ieee80211_band *band);
+
/*
* cfg80211_tdls_oper_request - request userspace to perform TDLS operation
* @dev: the device on which the operation is requested
*/
void cfg80211_unregister_wdev(struct wireless_dev *wdev);
+/**
+ * struct cfg80211_ft_event - FT Information Elements
+ * @ies: FT IEs
+ * @ies_len: length of the FT IE in bytes
+ * @target_ap: target AP's MAC address
+ * @ric_ies: RIC IE
+ * @ric_ies_len: length of the RIC IE in bytes
+ */
+struct cfg80211_ft_event_params {
+ const u8 *ies;
+ size_t ies_len;
+ const u8 *target_ap;
+ const u8 *ric_ies;
+ size_t ric_ies_len;
+};
+
+/**
+ * cfg80211_ft_event - notify userspace about FT IE and RIC IE
+ * @netdev: network device
+ * @ft_event: IE information
+ */
+void cfg80211_ft_event(struct net_device *netdev,
+ struct cfg80211_ft_event_params *ft_event);
+
/**
* cfg80211_get_p2p_attr - find and copy a P2P attribute from IE buffer
* @ies: the input IE buffer
struct cfg80211_wowlan_wakeup *wakeup,
gfp_t gfp);
+/**
+ * cfg80211_crit_proto_stopped() - indicate critical protocol stopped by driver.
+ *
+ * @wdev: the wireless device for which critical protocol is stopped.
+ *
+ * This function can be called by the driver to indicate it has reverted
+ * operation back to normal. One reason could be that the duration given
+ * by .crit_proto_start() has expired.
+ */
+void cfg80211_crit_proto_stopped(struct wireless_dev *wdev, gfp_t gfp);
+
/* Logging, debugging and troubleshooting/diagnostic helpers. */
/* wiphy_printk helpers, similar to dev_printk */
projects / cascardo / linux.git / blobdiff