* Station entries are added by mac80211 when you establish a link with a
* peer. This means different things for the different type of interfaces
* we support. For a regular station this mean we add the AP sta when we
- * receive an assocation response from the AP. For IBSS this occurs when
+ * receive an association response from the AP. For IBSS this occurs when
* get to know about a peer on the same IBSS. For WDS we add the sta for
- * the peer imediately upon device open. When using AP mode we add stations
+ * the peer immediately upon device open. When using AP mode we add stations
* for each respective station upon request from userspace through nl80211.
*
* In order to remove a STA info structure, various sta_info_destroy_*()
memcpy(sta->sta.addr, addr, ETH_ALEN);
sta->local = local;
sta->sdata = sdata;
+ sta->last_rx = jiffies;
ewma_init(&sta->avg_signal, 1024, 8);
#endif /* CONFIG_MAC80211_VERBOSE_DEBUG */
cancel_work_sync(&sta->drv_unblock_wk);
+ cfg80211_del_sta(sdata->dev, sta->sta.addr, GFP_KERNEL);
+
rate_control_remove_sta_debugfs(sta);
ieee80211_sta_debugfs_remove(sta);
if (!timer_needed)
return;
- local->sta_cleanup.expires =
- round_jiffies(jiffies + STA_INFO_CLEANUP_INTERVAL);
- add_timer(&local->sta_cleanup);
+ mod_timer(&local->sta_cleanup,
+ round_jiffies(jiffies + STA_INFO_CLEANUP_INTERVAL));
}
void sta_info_init(struct ieee80211_local *local)
setup_timer(&local->sta_cleanup, sta_info_cleanup,
(unsigned long)local);
- local->sta_cleanup.expires =
- round_jiffies(jiffies + STA_INFO_CLEANUP_INTERVAL);
-}
-
-int sta_info_start(struct ieee80211_local *local)
-{
- add_timer(&local->sta_cleanup);
- return 0;
}
void sta_info_stop(struct ieee80211_local *local)