From 216559d9032704a7a5d2fcd3c9c086dd9f7cd557 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Wed, 7 Sep 2016 15:53:31 +0200 Subject: [PATCH] net: smsc911x: augment device tree bindings This adds device tree bindings for: - An optional GPIO line for releasing the RESET signal to the SMSC911x devices - An optional PME (power management event) interrupt line that can be utilized to wake up the system on network activity. This signal exist on all the SMSC911x devices, it is just not very often routed. Both these lines are routed to the SoC on the Qualcomm APQ8060 Dragonboard and thus needs to be bound in the device tree. Cc: devicetree@vger.kernel.org Cc: Jeremy Linton Signed-off-by: Linus Walleij Acked-by: Arnd Bergmann Signed-off-by: David S. Miller --- .../devicetree/bindings/net/smsc911x.txt | 15 +++++++++++---- 1 file changed, 11 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/net/smsc911x.txt b/Documentation/devicetree/bindings/net/smsc911x.txt index 3fed3c124411..16c3a9501f5d 100644 --- a/Documentation/devicetree/bindings/net/smsc911x.txt +++ b/Documentation/devicetree/bindings/net/smsc911x.txt @@ -3,9 +3,11 @@ Required properties: - compatible : Should be "smsc,lan", "smsc,lan9115" - reg : Address and length of the io space for SMSC LAN -- interrupts : Should contain SMSC LAN interrupt line -- interrupt-parent : Should be the phandle for the interrupt controller - that services interrupts for this device +- interrupts : one or two interrupt specifiers + - The first interrupt is the SMSC LAN interrupt line + - The second interrupt (if present) is the PME (power + management event) interrupt that is able to wake up the host + system with a 50ms pulse on network activity - phy-mode : See ethernet.txt file in the same directory Optional properties: @@ -21,6 +23,10 @@ Optional properties: external PHY - smsc,save-mac-address : Indicates that mac address needs to be saved before resetting the controller +- reset-gpios : a GPIO line connected to the RESET (active low) signal + of the device. On many systems this is wired high so the device goes + out of reset at power-on, but if it is under program control, this + optional GPIO can wake up in response to it. Examples: @@ -29,7 +35,8 @@ lan9220@f4000000 { reg = <0xf4000000 0x2000000>; phy-mode = "mii"; interrupt-parent = <&gpio1>; - interrupts = <31>; + interrupts = <31>, <32>; + reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>; reg-io-width = <4>; smsc,irq-push-pull; }; -- 2.20.1