Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt

   1 TPO TPG110 Panel
   2 ================
   3
   4 This binding builds on the DPI bindings, adding a few properties
   5 as a superset of a DPI. See panel-dpi.txt for the required DPI
   6 bindings.
   7
   8 Required properties:
   9 - compatible : "tpo,tpg110"
  10 - grestb-gpios : panel reset GPIO
  11 - scen-gpios : serial control enable GPIO
  12 - scl-gpios : serial control clock line GPIO
  13 - sda-gpios : serial control data line GPIO
  14
  15 Required nodes:
  16 - Video port for DPI input, see panel-dpi.txt
  17 - Panel timing for DPI setup, see panel-dpi.txt
  18
  19 Example
  20 -------
  21
  22 panel {
  23         compatible = "tpo,tpg110", "panel-dpi";
  24         grestb-gpios = <&stmpe_gpio44 5 GPIO_ACTIVE_LOW>;
  25         scen-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
  26         scl-gpios = <&gpio0 5 GPIO_ACTIVE_HIGH>;
  27         sda-gpios = <&gpio0 4 GPIO_ACTIVE_HIGH>;
  28         backlight = <&bl>;
  29
  30         port {
  31                 nomadik_clcd_panel: endpoint {
  32                         remote-endpoint = <&nomadik_clcd_pads>;
  33                 };
  34         };
  35
  36         panel-timing {
  37                 clock-frequency = <33200000>;
  38                 hactive = <800>;
  39                 hback-porch = <216>;
  40                 hfront-porch = <40>;
  41                 hsync-len = <1>;
  42                 vactive = <480>;
  43                 vback-porch = <35>;
  44                 vfront-porch = <10>;
  45                 vsync-len = <1>;
  46         };
  47 };