Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/hid
[cascardo/linux.git] / Documentation / devicetree / bindings / display / tilcdc / tilcdc.txt
index 2136ee8..a83abd7 100644 (file)
@@ -17,6 +17,18 @@ Optional properties:
    the lcd controller.
  - max-pixelclock: The maximum pixel clock that can be supported
    by the lcd controller in KHz.
+ - blue-and-red-wiring: Recognized values "straight" or "crossed".
+   This property deals with the LCDC revision 2 (found on AM335x)
+   color errata [1].
+    - "straight" indicates normal wiring that supports RGB565,
+      BGR888, and XBGR8888 color formats.
+    - "crossed" indicates wiring that has blue and red wires
+      crossed. This setup supports BGR565, RGB888 and XRGB8888
+      formats.
+    - If the property is not present or its value is not recognized
+      the legacy mode is assumed. This configuration supports RGB565,
+      RGB888 and XRGB8888 formats. However, depending on wiring, the red
+      and blue colors are swapped in either 16 or 24-bit color modes.
 
 Optional nodes:
 
@@ -24,6 +36,18 @@ Optional nodes:
    binding follows Documentation/devicetree/bindings/graph.txt and
    suppors a single port with a single endpoint.
 
+ - See also Documentation/devicetree/bindings/display/tilcdc/panel.txt and
+   Documentation/devicetree/bindings/display/tilcdc/tfp410.txt for connecting
+   tfp410 DVI encoder or lcd panel to lcdc
+
+[1] There is an errata about AM335x color wiring. For 16-bit color mode
+    the wires work as they should (LCD_DATA[0:4] is for Blue[3:7]),
+    but for 24 bit color modes the wiring of blue and red components is
+    crossed and LCD_DATA[0:4] is for Red[3:7] and LCD_DATA[11:15] is
+    for Blue[3-7]. For more details see section 3.1.1 in AM335x
+    Silicon Errata:
+    http://www.ti.com/general/docs/lit/getliterature.tsp?baseLiteratureNumber=sprz360
+
 Example:
 
        fb: fb@4830e000 {
@@ -33,6 +57,8 @@ Example:
                interrupts = <36>;
                ti,hwmods = "lcdc";
 
+               blue-and-red-wiring = "crossed";
+
                port {
                        lcdc_0: endpoint@0 {
                                remote-endpoint = <&hdmi_0>;