#include <linux/i2c.h>
#include <linux/interrupt.h>
#include <linux/usb/musb.h>
-#include <asm/bfin6xx_spi.h>
+#include <asm/bfin_spi3.h>
#include <asm/dma.h>
#include <asm/gpio.h>
#include <asm/nand.h>
static unsigned short pins[] = P_RMII0;
static struct stmmac_mdio_bus_data phy_private_data = {
- .bus_id = 0,
.phy_mask = 1,
};
.type = "w25q32",
};
-static struct bfin6xx_spi_chip spi_flash_chip_info = {
+static struct bfin_spi3_chip spi_flash_chip_info = {
.enable_dma = true, /* use dma transfer with this chip*/
};
#endif
#if defined(CONFIG_SPI_SPIDEV) || defined(CONFIG_SPI_SPIDEV_MODULE)
-static struct bfin6xx_spi_chip spidev_chip_info = {
+static struct bfin_spi3_chip spidev_chip_info = {
.enable_dma = true,
};
#endif
},
#endif
};
-#if defined(CONFIG_SPI_BFIN6XX) || defined(CONFIG_SPI_BFIN6XX_MODULE)
+#if IS_ENABLED(CONFIG_SPI_BFIN_V3)
/* SPI (0) */
static struct resource bfin_spi0_resource[] = {
{
};
/* SPI controller data */
-static struct bfin6xx_spi_master bf60x_spi_master_info0 = {
+static struct bfin_spi3_master bf60x_spi_master_info0 = {
.num_chipselect = MAX_CTRL_CS + MAX_BLACKFIN_GPIOS,
.pin_req = {P_SPI0_SCK, P_SPI0_MISO, P_SPI0_MOSI, 0},
};
static struct platform_device bf60x_spi_master0 = {
- .name = "bfin-spi",
+ .name = "bfin-spi3",
.id = 0, /* Bus number */
.num_resources = ARRAY_SIZE(bfin_spi0_resource),
.resource = bfin_spi0_resource,
},
};
-static struct bfin6xx_spi_master bf60x_spi_master_info1 = {
+static struct bfin_spi3_master bf60x_spi_master_info1 = {
.num_chipselect = MAX_CTRL_CS + MAX_BLACKFIN_GPIOS,
.pin_req = {P_SPI1_SCK, P_SPI1_MISO, P_SPI1_MOSI, 0},
};
static struct platform_device bf60x_spi_master1 = {
- .name = "bfin-spi",
+ .name = "bfin-spi3",
.id = 1, /* Bus number */
.num_resources = ARRAY_SIZE(bfin_spi1_resource),
.resource = bfin_spi1_resource,
&bfin_sdh_device,
#endif
-#if defined(CONFIG_SPI_BFIN6XX) || defined(CONFIG_SPI_BFIN6XX_MODULE)
+#if IS_ENABLED(CONFIG_SPI_BFIN_V3)
&bf60x_spi_master0,
&bf60x_spi_master1,
#endif