X-Git-Url: http://git.cascardo.info/?p=cascardo%2Flinux.git;a=blobdiff_plain;f=drivers%2Fnet%2Fwireless%2Fiwlwifi%2Fpcie%2Ftrans.c;h=9ee4ca0ba8d37042b0cace64a1735c63daf21276;hp=09696ca2a654e4cfd685539d3ceaa5fed9a56385;hb=64bb1b944b554a751b518b09c3d596f6b6c0ce31;hpb=834437dab96c751bb013aaac86b19974f6cb444e

diff --git a/drivers/net/wireless/iwlwifi/pcie/trans.c b/drivers/net/wireless/iwlwifi/pcie/trans.c
index 09696ca2a654..9ee4ca0ba8d3 100644
--- a/drivers/net/wireless/iwlwifi/pcie/trans.c
+++ b/drivers/net/wireless/iwlwifi/pcie/trans.c
@@ -629,7 +629,7 @@ static int iwl_pcie_load_section(struct iwl_trans *trans, u8 section_num,
 {
 	u8 *v_addr;
 	dma_addr_t p_addr;
-	u32 offset, chunk_sz = section->len;
+	u32 offset, chunk_sz = min_t(u32, FH_MEM_TB_MAX_LENGTH, section->len);
 	int ret = 0;
 
 	IWL_DEBUG_FW(trans, "[%d] uCode section being loaded...\n",
@@ -1034,16 +1034,21 @@ static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
 	/* Stop the device, and put it in low power state */
 	iwl_pcie_apm_stop(trans, false);
 
-	/* Upon stop, the APM issues an interrupt if HW RF kill is set.
-	 * Clean again the interrupt here
+	/* stop and reset the on-board processor */
+	iwl_write32(trans, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
+	udelay(20);
+
+	/*
+	 * Upon stop, the APM issues an interrupt if HW RF kill is set.
+	 * This is a bug in certain verions of the hardware.
+	 * Certain devices also keep sending HW RF kill interrupt all
+	 * the time, unless the interrupt is ACKed even if the interrupt
+	 * should be masked. Re-ACK all the interrupts here.
 	 */
 	spin_lock(&trans_pcie->irq_lock);
 	iwl_disable_interrupts(trans);
 	spin_unlock(&trans_pcie->irq_lock);
 
-	/* stop and reset the on-board processor */
-	iwl_write32(trans, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
-	udelay(20);
 
 	/* clear all status bits */
 	clear_bit(STATUS_SYNC_HCMD_ACTIVE, &trans->status);