KVM: MMU: fix ept=0/pte.u=1/pte.w=0/CR0.WP=0/CR4.SMEP=1/EFER.NX=0 combo

KVM: MMU: fix ept=0/pte.u=1/pte.w=0/CR0.WP=0/CR4.SMEP=1/EFER.NX=0 combo

Yes, all of these are needed. :) This is admittedly a bit odd, but
kvm-unit-tests access.flat tests this if you run it with "-cpu host"
and of course ept=0.

KVM runs the guest with CR0.WP=1, so it must handle supervisor writes
specially when pte.u=1/pte.w=0/CR0.WP=0.  Such writes cause a fault
when U=1 and W=0 in the SPTE, but they must succeed because CR0.WP=0.
When KVM gets the fault, it sets U=0 and W=1 in the shadow PTE and
restarts execution.  This will still cause a user write to fault, while
supervisor writes will succeed.  User reads will fault spuriously now,
and KVM will then flip U and W again in the SPTE (U=1, W=0).  User reads
will be enabled and supervisor writes disabled, going back to the
originary situation where supervisor writes fault spuriously.

When SMEP is in effect, however, U=0 will enable kernel execution of
this page.  To avoid this, KVM also sets NX=1 in the shadow PTE together
with U=0.  If the guest has not enabled NX, the result is a continuous
stream of page faults due to the NX bit being reserved.

The fix is to force EFER.NX=1 even if the CPU is taking care of the EFER
switch.  (All machines with SMEP have the CPU_LOAD_IA32_EFER vm-entry
control, so they do not use user-return notifiers for EFER---if they did,
EFER.NX would be forced to the same value as the host).

There is another bug in the reserved bit check, which I've split to a
separate patch for easier application to stable kernels.

Cc: stable@vger.kernel.org
Cc: Andy Lutomirski <luto@amacapital.net>
Reviewed-by: Xiao Guangrong <guangrong.xiao@linux.intel.com>
Fixes: f6577a5fa15d82217ca73c74cd2dcbc0f6c781dd
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>