ath10k: align RX frames properly

Ethernet-like decapping mode leaves IP protocol
frame not aligned to 4-byte boundaries. This leads
to re-aligning in mac80211 which in turn leads to
poor CPU cache behaviour on some machines.

Since HW doesn't allow to change payload offset
properly the solution is to force HW to decap in
Native Wifi mode which always has 24-bytes long
802.11 header (even for QoS frames). This means IP
frame is properly aligned in this decap mode.

Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

diff --git a/drivers/net/wireless/ath/ath10k/hw.h b/drivers/net/wireless/ath/ath10k/hw.h
index 643f0c9..8c1be76 100644 (file)
--- a/drivers/net/wireless/ath/ath10k/hw.h
+++ b/drivers/net/wireless/ath/ath10k/hw.h
@@ -74,7 +74,11 @@ enum ath10k_mcast2ucast_mode {
 #define TARGET_RX_CHAIN_MASK                   (BIT(0) | BIT(1) | BIT(2))
 #define TARGET_RX_TIMEOUT_LO_PRI               100
 #define TARGET_RX_TIMEOUT_HI_PRI               40
-#define TARGET_RX_DECAP_MODE                   ATH10K_HW_TXRX_ETHERNET
+
+/* Native Wifi decap mode is used to align IP frames to 4-byte boundaries and
+ * avoid a very expensive re-alignment in mac80211. */
+#define TARGET_RX_DECAP_MODE                   ATH10K_HW_TXRX_NATIVE_WIFI
+
 #define TARGET_SCAN_MAX_PENDING_REQS           4
 #define TARGET_BMISS_OFFLOAD_MAX_VDEV          3
 #define TARGET_ROAM_OFFLOAD_MAX_VDEV           3