1 * Freescale Fast Ethernet Controller (FEC)
4 - compatible : Should be "fsl,<soc>-fec"
5 - reg : Address and length of the register set for the device
6 - interrupts : Should contain fec interrupt
7 - phy-mode : See ethernet.txt file in the same directory
10 - phy-reset-gpios : Should specify the gpio for phy reset
11 - phy-reset-duration : Reset duration in milliseconds. Should present
12 only if property "phy-reset-gpios" is available. Missing the property
13 will have the duration be 1 millisecond. Numbers greater than 1000 are
14 invalid and 1 millisecond will be used instead.
15 - phy-supply : regulator that powers the Ethernet PHY.
16 - phy-handle : phandle to the PHY device connected to this device.
17 - fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
18 Use instead of phy-handle.
19 - fsl,num-tx-queues : The property is valid for enet-avb IP, which supports
20 hw multi queues. Should specify the tx queue number, otherwise set tx queue
22 - fsl,num-rx-queues : The property is valid for enet-avb IP, which supports
23 hw multi queues. Should specify the rx queue number, otherwise set rx queue
27 - mdio : specifies the mdio bus in the FEC, used as a container for phy nodes
28 according to phy.txt in the same directory
33 compatible = "fsl,imx51-fec", "fsl,imx27-fec";
34 reg = <0x83fec000 0x4000>;
37 phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
38 local-mac-address = [00 04 9F 01 1B B9];
39 phy-supply = <®_fec_supply>;
42 Example with phy specified:
45 compatible = "fsl,imx51-fec", "fsl,imx27-fec";
46 reg = <0x83fec000 0x4000>;
49 phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
50 local-mac-address = [00 04 9F 01 1B B9];
51 phy-supply = <®_fec_supply>;
52 phy-handle = <ðphy>;
54 ethphy: ethernet-phy@6 {
55 compatible = "ethernet-phy-ieee802.3-c22";