+static int ath10k_pci_chip_reset(struct ath10k *ar)
+{
+ int i, ret;
+ u32 val;
+
+ ath10k_dbg(ar, ATH10K_DBG_BOOT, "boot chip reset\n");
+
+ /* Some hardware revisions (e.g. CUS223v2) has issues with cold reset.
+ * It is thus preferred to use warm reset which is safer but may not be
+ * able to recover the device from all possible fail scenarios.
+ *
+ * Warm reset doesn't always work on first try so attempt it a few
+ * times before giving up.
+ */
+ for (i = 0; i < ATH10K_PCI_NUM_WARM_RESET_ATTEMPTS; i++) {
+ ret = ath10k_pci_warm_reset(ar);
+ if (ret) {
+ ath10k_warn(ar, "failed to warm reset attempt %d of %d: %d\n",
+ i + 1, ATH10K_PCI_NUM_WARM_RESET_ATTEMPTS,
+ ret);
+ continue;
+ }
+
+ /* FIXME: Sometimes copy engine doesn't recover after warm
+ * reset. In most cases this needs cold reset. In some of these
+ * cases the device is in such a state that a cold reset may
+ * lock up the host.
+ *
+ * Reading any host interest register via copy engine is
+ * sufficient to verify if device is capable of booting
+ * firmware blob.
+ */
+ ret = ath10k_pci_init_pipes(ar);
+ if (ret) {
+ ath10k_warn(ar, "failed to init copy engine: %d\n",
+ ret);
+ continue;
+ }
+
+ ret = ath10k_pci_diag_read32(ar, QCA988X_HOST_INTEREST_ADDRESS,
+ &val);
+ if (ret) {
+ ath10k_warn(ar, "failed to poke copy engine: %d\n",
+ ret);
+ continue;
+ }
+
+ ath10k_dbg(ar, ATH10K_DBG_BOOT, "boot chip reset complete (warm)\n");
+ return 0;
+ }
+
+ if (ath10k_pci_reset_mode == ATH10K_PCI_RESET_WARM_ONLY) {
+ ath10k_warn(ar, "refusing cold reset as requested\n");
+ return -EPERM;
+ }
+
+ ret = ath10k_pci_cold_reset(ar);
+ if (ret) {
+ ath10k_warn(ar, "failed to cold reset: %d\n", ret);
+ return ret;
+ }
+
+ ret = ath10k_pci_wait_for_target_init(ar);
+ if (ret) {
+ ath10k_warn(ar, "failed to wait for target after cold reset: %d\n",
+ ret);
+ return ret;
+ }
+
+ ath10k_dbg(ar, ATH10K_DBG_BOOT, "boot chip reset complete (cold)\n");
+
+ return 0;
+}
+
+static int ath10k_pci_hif_power_up(struct ath10k *ar)