ARM: dts: am437x: Provide NAND ready pin

On these boards NAND ready pin status is avilable over
GPMC_WAIT0 pin.

For NAND we don't use GPMC wait pin monitoring but
get the NAND Ready/Busy# status using GPIOlib.
GPMC driver provides the WAIT0 pin status over GPIOlib.

Read speed increases from 16516 KiB/ to 18813 KiB/s
and write speed was unchanged at 9941 KiB/s.

Measured using mtd_speedtest.ko.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

diff --git a/arch/arm/boot/dts/am437x-gp-evm.dts b/arch/arm/boot/dts/am437x-gp-evm.dts
index 95ec82a..5bcd3aa 100644 (file)
--- a/arch/arm/boot/dts/am437x-gp-evm.dts
+++ b/arch/arm/boot/dts/am437x-gp-evm.dts
@@ -817,6 +817,7 @@
                interrupt-parent = <&gpmc>;
                interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
                             <1 IRQ_TYPE_NONE>; /* termcount */
+               rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>;  /* gpmc_wait0 */
                ti,nand-ecc-opt = "bch16";
                ti,elm-id = <&elm>;
                nand-bus-width = <8>;

diff --git a/arch/arm/boot/dts/am43x-epos-evm.dts b/arch/arm/boot/dts/am43x-epos-evm.dts
index d797823..965d548 100644 (file)
--- a/arch/arm/boot/dts/am43x-epos-evm.dts
+++ b/arch/arm/boot/dts/am43x-epos-evm.dts
@@ -568,6 +568,7 @@
                interrupt-parent = <&gpmc>;
                interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
                             <1 IRQ_TYPE_NONE>; /* termcount */
+               rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>;  /* gpmc_wait0 */
                ti,nand-ecc-opt = "bch16";
                ti,elm-id = <&elm>;
                nand-bus-width = <8>;