be2net: remove redundant D0 power state set

pci_enable_device() call sets device power state to D0; there is no need
doing it again.

Signed-off-by: Kalesh AP <kalesh.purayil@avagotech.com>
Signed-off-by: Sathya Perla <sathya.perla@avagotech.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index f21c56a..8b81e23 100644 (file)
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c
@@ -5807,7 +5807,6 @@ static int be_pci_resume(struct pci_dev *pdev)
        if (status)
                return status;
 
-       pci_set_power_state(pdev, PCI_D0);
        pci_restore_state(pdev);
 
        status = be_resume(adapter);
@@ -5887,7 +5886,6 @@ static pci_ers_result_t be_eeh_reset(struct pci_dev *pdev)
                return PCI_ERS_RESULT_DISCONNECT;
 
        pci_set_master(pdev);
-       pci_set_power_state(pdev, PCI_D0);
        pci_restore_state(pdev);
 
        /* Check if card is ok and fw is ready */