ath10k: enable per-vif sta powersave

Per-vif bss_conf.ps should be used to configure
powersave.

Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index 2804952..19ddbc6 100644 (file)
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -1099,9 +1099,6 @@ static int ath10k_mac_vif_recalc_ps_poll_count(struct ath10k_vif *arvif)
        return 0;
 }
 
-/*
- * Review this when mac80211 gains per-interface powersave support.
- */
 static int ath10k_mac_vif_setup_ps(struct ath10k_vif *arvif)
 {
        struct ath10k *ar = arvif->ar;
@@ -1117,7 +1114,7 @@ static int ath10k_mac_vif_setup_ps(struct ath10k_vif *arvif)
        if (arvif->vif->type != NL80211_IFTYPE_STATION)
                return 0;
 
-       if (conf->flags & IEEE80211_CONF_PS) {
+       if (vif->bss_conf.ps) {
                psmode = WMI_STA_PS_MODE_ENABLED;
                param = WMI_STA_PS_PARAM_INACTIVITY_TIME;
 
@@ -3378,6 +3375,13 @@ static void ath10k_bss_info_changed(struct ieee80211_hw *hw,
                        ath10k_warn(ar, "failed to recalc tx power: %d\n", ret);
        }
 
+       if (changed & BSS_CHANGED_PS) {
+               ret = ath10k_mac_vif_setup_ps(arvif);
+               if (ret)
+                       ath10k_warn(ar, "failed to setup ps on vdev %i: %d\n",
+                                   arvif->vdev_id, ret);
+       }
+
        mutex_unlock(&ar->conf_mutex);
 }