ath9k_hw: remove debugging masks from AR_MCI_INTERRUPT_RX_MSG_DEFAULT

Remove the CONT_* and LNA_* messages from
AR_MCI_INTERRUPT_RX_MSG_DEFAULT. Those MCI rx messages only
meant for debugging purpose. Including them in default rx_msg
series could raise huge amount of MCI interrupts when BT traffic
is going on. And also it increases power consumption when WLAN
is scanning.

Signed-off-by: Rajkumar Manoharan <rmanohar@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

diff --git a/drivers/net/wireless/ath/ath9k/reg.h b/drivers/net/wireless/ath/ath9k/reg.h
index 22d2413..6592c07 100644 (file)
--- a/drivers/net/wireless/ath/ath9k/reg.h
+++ b/drivers/net/wireless/ath/ath9k/reg.h
@@ -2081,12 +2081,6 @@ enum {
                                         AR_MCI_INTERRUPT_RX_MSG_REMOTE_RESET| \
                                         AR_MCI_INTERRUPT_RX_MSG_SYS_WAKING  | \
                                         AR_MCI_INTERRUPT_RX_MSG_SYS_SLEEPING| \
-                                        AR_MCI_INTERRUPT_RX_MSG_SCHD_INFO   | \
-                                        AR_MCI_INTERRUPT_RX_MSG_LNA_CONTROL | \
-                                        AR_MCI_INTERRUPT_RX_MSG_LNA_INFO    | \
-                                        AR_MCI_INTERRUPT_RX_MSG_CONT_NACK   | \
-                                        AR_MCI_INTERRUPT_RX_MSG_CONT_INFO   | \
-                                        AR_MCI_INTERRUPT_RX_MSG_CONT_RST    | \
                                         AR_MCI_INTERRUPT_RX_MSG_REQ_WAKE)
 
 #define AR_MCI_CPU_INT                                 0x1840