ARM: dts: armada-388-clearfog: remove duplicate mdio entry

The clearfog DTS should not be defining the on-board phy, this device
is located on the microsom.  Remove the duplicated definition.

Reported-by: Jon Nettleton <jon@solid-run.com>
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com>

diff --git a/arch/arm/boot/dts/armada-388-clearfog.dts b/arch/arm/boot/dts/armada-388-clearfog.dts
index c60206e..2e0556a 100644 (file)
--- a/arch/arm/boot/dts/armada-388-clearfog.dts
+++ b/arch/arm/boot/dts/armada-388-clearfog.dts
@@ -239,22 +239,6 @@
                                status = "okay";
                        };
 
-                       mdio@72004 {
-                               pinctrl-0 = <&mdio_pins>;
-                               pinctrl-names = "default";
-
-                               phy_dedicated: ethernet-phy@0 {
-                                       /*
-                                        * Annoyingly, the marvell phy driver
-                                        * configures the LED register, rather
-                                        * than preserving reset-loaded setting.
-                                        * We undo that rubbish here.
-                                        */
-                                       marvell,reg-init = <3 16 0 0x101e>;
-                                       reg = <0>;
-                               };
-                       };
-
                        pinctrl@18000 {
                                clearfog_dsa0_clk_pins: clearfog-dsa0-clk-pins {
                                        marvell,pins = "mpp46";