dts: sun8i-h3: add I2C0-2 peripherals to H3 SOC

These peripherals can only be muxed to these pins, so they are
associated in the DTSI instead of the board files. This makes it very
easy to enable them using overlays or u-boot commands:

 => fdt set /soc/i2c@01c2ac00 status okay

Signed-off-by: Jorik Jonker <jorik@kippendief.biz>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>

diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
index 2c958c4..99e6640 100644 (file)
--- a/arch/arm/boot/dts/sun8i-h3.dtsi
+++ b/arch/arm/boot/dts/sun8i-h3.dtsi
@@ -491,6 +491,45 @@
                        status = "disabled";
                };
 
+               i2c0: i2c@01c2ac00 {
+                       compatible = "allwinner,sun6i-a31-i2c";
+                       reg = <0x01c2ac00 0x400>;
+                       interrupts = <GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>;
+                       clocks = <&ccu CLK_BUS_I2C0>;
+                       resets = <&ccu RST_BUS_I2C0>;
+                       pinctrl-names = "default";
+                       pinctrl-0 = <&i2c0_pins>;
+                       status = "disabled";
+                       #address-cells = <1>;
+                       #size-cells = <0>;
+               };
+
+               i2c1: i2c@01c2b000 {
+                       compatible = "allwinner,sun6i-a31-i2c";
+                       reg = <0x01c2b000 0x400>;
+                       interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>;
+                       clocks = <&ccu CLK_BUS_I2C1>;
+                       resets = <&ccu RST_BUS_I2C1>;
+                       pinctrl-names = "default";
+                       pinctrl-0 = <&i2c1_pins>;
+                       status = "disabled";
+                       #address-cells = <1>;
+                       #size-cells = <0>;
+               };
+
+               i2c2: i2c@01c2b400 {
+                       compatible = "allwinner,sun6i-a31-i2c";
+                       reg = <0x01c2b000 0x400>;
+                       interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>;
+                       clocks = <&ccu CLK_BUS_I2C2>;
+                       resets = <&ccu RST_BUS_I2C2>;
+                       pinctrl-names = "default";
+                       pinctrl-0 = <&i2c2_pins>;
+                       status = "disabled";
+                       #address-cells = <1>;
+                       #size-cells = <0>;
+               };
+
                gic: interrupt-controller@01c81000 {
                        compatible = "arm,cortex-a7-gic", "arm,cortex-a15-gic";
                        reg = <0x01c81000 0x1000>,